Hej som overskriften lyder er flasken Tom det en argon mix "så vidt jeg kan se"
Er der nogle som har viden om hvor jeg får genopfyldt sådan en satan i Kbh området - ?

Påforhånd tak

 

argon mix? :S Hvad skal det bruges til ? Aldrig hørt om det. Normalt plejer argon at være til Tig, og co2 til mag/mig.

 

Eventuelt Elektroma i Albertslund

 

Blandingen hedder Krysal gas. Giver en meget bedre og renere svejseresultat end ren CO2
Min afdøde fader brugte altid denne gas til at svejse med

sakset fra nettet.

The technology

For MAG welding of non-alloyed and low alloy steels Messer supplies a variety of argon-blends.
Standard argon mixtures:
Proved standard argon mixtures include Krysal® 18 with 18 % CO2, Argoline® D with 8 % oxygen and the 3 component mixture Argoline® 10.
Oxygen reduces spatter. Higher CO2-contents have a favorable effect in case of difficult welding positions. For special applications pure CO2 is used, such as when welding with cored wire electrodes.
Low activity shielding gases:
With Krysal® 8 and Argoline® 4 there is a trend to low activity shielding gases. Less slag and spatter effectively reduce the production costs.
In addition, the mechanical properties of the weld seam are greatly improved. The German national railway (Deutsche Bahn) has approved Argoline® 4 for bridge constructions. This shows the high quality potential of shielding gases with low activity components. These gases are also suit-able for high performance welding.

Your advantages at a glance

- high deposition rate
- easy handling

Used gases
• CO2
•Ferroline®
•Ferroline® C15 X5
•Inoxline®
•Specialty Gases

 

Tak

 

Rehermanns Ilt & Gas i Roskilde er nemme at snakke med og flår dig ikke.
http://www.svejsecenteret.dk